Ariens Platinum 30 Operator's Manual download pdf (Page 13)

Step Four:

Install Discharge Chute Rod Cont.

4. Hook the chute control cable onto the chute rod.

IMPORTANT: The chute control cable hook will prevent the cable

from contacting the engine or muffler guard. Make sure the cable

stays connected while unit is in operation.

5. Check to make sure the chute control cable ends are properly

seated in control assembly and control arm.

6. Replace gear cover on top of chute pedestal.

7. Orient the chute and pedestal to its most vertical position and

tighten pedestal hardware to 15-31 lbf-ft (20-42 N∙m).

8. Make sure the discharge chute rotates left and right when you

push the discharge chute control lever left and right.

NOTE: If chute does not stay in position, adjust as directed in

Discharge Chute Control in Owner Manual.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

No comments

Ariens Platinum 30 Operator's Manual Page 13