Ariens 946101 Specifications download pdf (Page 6)

GB - 6

This product is equipped with an internal

combustion engine. DO NOT use on or near

any unimproved, forest or brush covered land

unless the exhaust system is equipped with a

spark arrestor meeting applicable local, state

or federal laws. A spark arrestor, if used, must

be maintained in effective working order by the

operator. See your Ariens Dealer or engine

manufacturer’s service center.

Fuel is highly flammable and its vapors can

explode. ONLY use approved fuel containers.

• NO Smoking!

• NO Sparks!

• NO Flames!

• Allow engine to cool before filling fuel

tank.

Never fill containers inside a vehicle or on a

truck or trailer bed with a plastic liner. Always

place containers on the ground away from

your vehicle before filling.

When practical, remove gas-powered

equipment from the truck or trailer and refuel it

on the ground. If this is not possible, then

refuel such equipment on a trailer with a

portable container, rather than from a gasoline

dispenser nozzle.

Keep the nozzle in contact with the rim of the

fuel tank or container opening at all times until

fueling is complete. Do not use a nozzle lock-

open device.

Check fuel supply before starting engine.

DO NOT fill gasoline tank indoors, when

engine is running, or while engine is hot.

Allow engine to cool several minutes before

removing fuel cap.

DO NOT overfill. Allow about 1/4" (6 mm) of

tank space for fuel expansion.

Replace gasoline tank cap securely and clean

any spilled fuel before starting engine.

If fuel is spilled on clothing, change clothing

immediately.

NEVER store fuel inside where there is an

open flame, such as a water heater.

ALWAYS drain fuel outdoors away from

ignition sources.

Avoid Electric Shock. DO NOT disconnect

wire from spark plug while engine is running.

Accidental engine start up can cause death or

serious injury. Except where specifically

recommended, ALWAYS stop engine, wait for

moving parts to stop, allow parts to cool and

disconnect spark plug wire before inspecting,

servicing, adjusting or repairing unit.

Keep unit free of grass, leaves, or other debris

build-up.

Keep equipment in good condition.

Maintain or replace safety and instruction

labels, as necessary.

Follow engine manufacturer’s safety

instructions when servicing engine.

Check all hardware at regular intervals,

especially trimmer head attachment bolts.

Keep all hardware properly tightened.

Before tipping unit, remove fuel.

DO NOT tip the trimmer up or over unless

specifically instructed to do so.

Ensure all wheel blocks, jack stands and tie

downs will support unit during maintenance.

Replace worn-out mufflers immediately.

Continued use could result in fire or explosion.

Sharp edges can cut or amputate fingers or a

hand. Wrap blade or wear sturdy gloves to

service.

Use only replacement parts designed for your

unit. See your Ariens Dealer.

Allow engine to cool before storing in any

enclosure.

ALWAYS clean unit before extended storage.

See engine manual for proper storage.

DO NOT store unit inside a building with fuel in

the fuel tank where any ignition sources are

present.

Use only accessories which have been

approved by Ariens and are properly installed.

Check attachments frequently and replace

worn or damaged components with

manufacturer’s recommended parts.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments