Ariens 946101 Specifications download pdf (Page 15)

GB - 15

To remove the old belt:

1. Stop the engine and wait for all moving

parts to stop. Disconnect the spark plug

wire and place it securely away from the

spark plug.

2. Place unit in service position (see

Maintenance section).

3. Remove the six (6) hex washer head

screws and the trimmer shield.

4. Remove the four (4) hex washer head

screws on the top side of the frame. The

jackshaft assembly, belt fingers and

jackshaft spacers will now be loose.

5. Remove the v-belt from the jackshaft

pulley.

6. Remove the capscrew and lock washer

from the engine sheave.

7. Lower the engine sheave past the belt

fingers and remove the belt.

To install the new belt:

1. Slide the new belt over the groove in the

engine sheave and slide the sheave

against the engine. Make sure the belt is

in the groove and is inside the belt fingers.

2. Install the capscrew and lock washer.

Tighten securely.

3. Slide the belt between the idler and belt

finger on the idler bracket.

4. Install the four tapping screws in the holes

in the frame, from the top side of the

frame.

5. Install the four jackshaft spacers on the

tapping screws.

6. Install the belt finger. Make sure the bent

tabs are facing up and are to the sides

and front of the unit.

7. Install the belt in the groove of the

jackshaft pulley.

8. Attach the jackshaft assembly to the

frame with the four tapping screws.

Fasten securely.

9. Reinstall the trimmer shield with the six

tapping screws.

4

3

2

1

7

6

5

1. Engine sheave

belt fingers

2. Engine sheave

3. Idler

4. Idler belt finger

5. V-belt

6. Jackshaft

pulley belt

fingers

7. Jackshaft

pulley

OX0100

CAUTION: Before tipping unit,

remove enough fuel so no spillage

will occur. A piece of plastic bag

may be used to seal fuel tank when

tipping unit. To seal, remove fuel

tank cap, cover fuel tank opening

with plastic, replace and tighten

cap securely before attempting to

tip unit. Be sure to remove plastic

before operating unit.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments