Ariens 22-Ton Log Splitter Specifications download pdf (Page 32)

4. Refill the hydraulic tank.

a. Reconnect inlet hose (2) to the pump.

b. Remove the hydraulic tank fill cap and

fill the tank with the recommended

type and quantity of oil. Replace the

cap.

5. Drain and refill the piston end of the

cylinder.

a. Hold the valve handle in the retract

position and pull the engine pull start

cord until the rod is fully retracted.

This step removes the old oil from the

piston end of the cylinder.

b. Reconnect return hose (1) to the oil

filter.

c. Extend the cylinder by holding the

valve handle forward and pulling on

the engine’s pull start cord until the

cylinder is completely extended. This

step refills the piston end of the cylin-

der.

6. Start the engine and cycle the cylinder.

a. Replace the spark plug and spark plug

wire.

b. Start the engine and cycle the

cylinder several times.

c. Retract the cylinder and shut off the

engine.

d. Recheck the hydraulic tank to make

sure oil is filled within approximately

one inch from the top of the tank.

Iron & Oak 30 815-672-8596

Inspection and Maintenance

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

No comments

Ariens 22-Ton Log Splitter Specifications Page 32