Ariens 22-Ton Log Splitter Specifications download pdf (Page 24)

3. Start the engine using the instructions from

the engine manual. If the log splitter has

not been running (cold engine), warm up

the engine and hydraulic system by run-

ning the engine at half throttle for 3 to 4

minutes, then advance the engine throttle

control to maximum speed.

Operation – Horizontal Position

Before loading and operating the log splitter,

always wear protective gear, such as safety

goggles, face shield, hearing protection,

tight-fitting gloves without draw strings or loose cuffs, and steel-toed shoes.

4. Use the following photos for the correct

and incorrect methods of splitting logs.

Never split a log using an incorrect or

unsafe method.

a. Place the log on the log splitter. Grasp

the log on the sides near the middle of

the block. Center the log, side-to-side,

on the rail of the log splitter, making

sure that the sawed end is against the

large plate (base plate) at the opposite

end of the hydraulic control valve con-

trol lever.

Do not place your hands on the

ends of the log when loading the

log splitter. This is a very

UNSAFE method and could result in injury

to your hands.

CAUTION

WARNING

Iron & Oak 22 815-672-8596

Operation

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

No comments

Ariens 22-Ton Log Splitter Specifications Page 24