Ariens 22-Ton Log Splitter Specifications download pdf (Page 19)

Important Notice

Do not start the engine. Follow all of the instructions in the “Start-up Pro-

cedure” before operating the log splitter. Failure to follow this recommen-

dation will result in engine and hydraulic pump damage.

If this log splitter is purchased without an engine, the customer assumes all liabilities that

might arise from an engine that is incompatible with the design of the log splitter. Also,

any unauthorized changes or modifications to the log splitter will void all warranties.

IMPORTANT: The hydraulic system oil filter, for your log splitter, is not factory installed.

Make sure the filter is installed before attempting to fill the hydraulic tank or start the

engine. (Installation instructions are provided in the “Assembly Instructions” section and

are also printed on the side of the filter).

IMPORTANT: Before starting the engine, read the engine manufacturer’s operating and

maintenance instruction manual. If an engine manual was not supplied with the log split-

ter, it is your responsibility to obtain a manual. Start by contacting the store where you

purchased the log splitter. If they cannot help you, contact the engine manufacturer.

1. Fill the hydraulic tank with SAE 10W tractor hydraulic oil or automatic transmission

fluid, such as Dextron III. The tank is full when the oil level is approximately one inch

from the top of the tank. Do not tighten the fill cap at this time.

NOTE: The total hydraulic system oil capacity for all units is 9.5 gallons.

2. Fill the engine’s crank case with the engine manufacturer’s recommended oil.

3. Lubricate the surface of slide rail with grease. This will help to prevent wear between

the slide plates and the slide rail.

4. Remove the spark plug wire from the engine. This prevents the engine from starting

until the hydraulic pump and cylinder are completely filled with oil. Make sure the

spark plug wire is held away from the spark plug with string or other nonconductive

material.

5. Push the valve control handle to the forward position (towards the front of the cylin-

der) with one hand. Pull the engine starter cord (about 15 times) with the other hand,

until the cylinder piston moves forward. (Keep everything away from the splitting

wedge during this step.)

NOTE: Extending the cylinder draws the hydraulic fluid through the system and expels

any trapped air in the cylinder.

815-672-8596 17 Iron & Oak

Start-Up Procedure

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

No comments

Ariens 22-Ton Log Splitter Specifications Page 19