Ariens SNO-THRO 932 User Manual download pdf (Page 16)

Lubrication and Maintenance (Continued)

Oil and Grease Locations

CAUTION: DO NOT touch engine or

Sno-Thro drive parts which are hot from

operation. Allow such parts to cool

before servicing unit.

IMPORTANT: Wipe each fitting clean before and

after lubrication,

NOTE: Use Ariens Multi-Purpose Grease (Part No.

000150) or good grade of general purpose grease at

zerk fittings and oil at lubrication points.

Sno-Thro should be lubricated at beginning of season

and every 25 operating hours. Grease and oiling

points are indicated below.

IMPORTANT: DO NOT allow grease or oil to get on

belt or friction wheel.

NOTE: To grease one auger shaft at a time, remove

shear bolt nut and shear bolt. Turn auger on shaft

while applying grease through zerk fitting. Replace

shear bolt per instructions in Shear Bolt

Replacement.

1. Traction Rod

2. Speed Selector Linkage

3. Bushing

4. Hex Shaft

5. Discharge Chute Base

6. Auger and Shaft

Figure 12: Oil and Grease Locations

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Ariens SNO-THRO 932 User Manual Page 16