Ariens SNO-THRO 932 User Manual download pdf (Page 12)

Operation (Continued)

Speed Selector

CAUTION: DO NOT overload machine

capacity by attempting to clear snow at

too fast a rate.

CAUTION: Operate equipment only with

good visibility and light.

Speed Selector controls units forward speed and

reverse motion. Moving Speed Selector forward

increases forward travel speed. Moving it to rear

decreases forward motion and/or engages reverse

motion.

IMPORTANT: Position Speed Selector in notch of

desired speed. Forward speed can be changed

without clutching. DO NOT change motion from

forward to reverse with clutch engaged.

NOTE: Low speed (1) is recommended for removing

deep or hard packed snow.

Wheel Drive Clutch

CAUTION: Stay alert for holes, rocks,

roots and hidden hazards in area of

operation. Exercise extreme caution

when operating on or crossing gravei

drives, walks or roads. Stay alert for

hidden hazards or traffic.

A downward force on Wheel Drive Clutch Lever

engages wheel drive for propelling unit. Releasing

Wheel Drive Clutch Lever stops forward or reverse

movement.

CAUTION: Disengage power to

auger/impeller when unit is being

transported or is not in use. DO NOT

operate unit at high transport speeds on

slippery surfaces. Use care when

backing.

NOTE: When transporting unit to or from area to be

cleared, press down on handlebars enough to raise

front of Sno-Thro slightly off surface and engage

Wheel Drive Clutch without engaging Attachment

Drive Clutch.

Attachment Drive Clutch

3. Discharge Chute Crank Rod

4. Speed Selector

Figure 7: Operating Components

A downward force on Attachment Drive Clutch Lever

engages attachment and releasing it disengages

attachment.

NOTE: Attachment clutch should be engaged before

wheel drive clutch when attempting to throw snow.

To clear an area, run Sno-Thro in an overlapping

series of paths. For large areas start in middle and

throw snow to each side so you do not have to move

it more than once.

Stopping

WARNING: Take all possible

precautions when leaving unit

unattended, such as disengaging power

to attachment, stopping engine and

removing key to prevent unauthorized

use.

IMPORTANT: Run attachment a few minutes after

throwing snow to prevent freeze-up of auger/impeller.

Release Attachment Drive Clutch, throttle down and

turn engine Ignition Key to “OFF.

CAUTION: Stop engine and remove wire

from spark piug after striking a foreign

object. Thoroughly inspect Sno-Thro for

any damage and repair damage before

restarting and operating unit.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Comments to this Manuals

No comments

Ariens SNO-THRO 932 User Manual Page 12

Comments to this Manuals