Ariens 991074-Max Zoom 52 Specifications download pdf (Page 16)

Before Each Use

1. Check bagger parts for wear, deterioration or

damage. Replace ONLY with original manufacturer

service parts before operating.

2. Make sure counterweights are installed.

3. Make sure all hardware is tight.

IMPORTANT: Check tool-less hardware often. Tighten as

needed.

4. Remove any grass buildup from bagger parts.

5. Make sure hose is fastened securely on upper boot

and blower assembly.

6. Make sure mesh bags are installed, and the bagger

cover is closed and securely latched.

Bagging

Starting

1. Start engine and engage PTO according to unit

owner’s manual.

2. Set throttle to full.

3. Choose a slow ground speed.

Shut Off

1. Disengage PTO.

2. Shut off unit according to unit Owner/Operator’s

manual.

Emptying mesh Bags

If bagger stops picking up grass clippings, mesh bags

may be full.

To empty bags:

1. Disengage PTO, stop engine and remove ignition

key. Wait for all moving parts to stop before leaving

operator’s position.

2. Empty the grass from each bag.

3. Clean out hose.

4. Close and latch cover.

Unclogging Bagger

If hose or blower assembly gets clogged, stop forward

motion and allow unit to clear itself. If unit will not clear

itself, unclog the hose and/or blower assembly manually

as instructed below.

1. Stop engine and remove ignition key. Wait for all

moving parts to stop.

2. Lift thumb latch on bagger assembly and remove

hose (figure 14).

3. Remove hose from blower assembly.

NOTE: Perform steps 4 and 5 if clog is in the hose:

4. Remove clogged grass.

5. Reinstall hose.

NOTE: Perform steps 6 and 7 if clog is in blower

assembly.

6. Clear grass from blower assembly.

7. Reinstall hose and close the thumb latch.

Operating Tips

• Cut grass when it is dry.

• Cut grass in two passes when cutting thick, long, or

wet grass. Make the first cut higher than desired.

Make the second cut at desired height.

• Always use full throttle when bagging.

OPERATION

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

WARNING: Do not operate on slopes over 10°

DO NOT operate mower unless guards are in

place or blower assembly and entire bagger are

attached.

WARNING: Lower attachment, stop engine, and

remove key to prevent unauthorized use. DO

NOT park on slopes.

WARNING: MOVING PARTS can cut or

amputate body parts.

NEVER attempt to clear blower assembly while

engine is running.

ALWAYS stop engine, remove key, and wait for

moving parts to stop.

Sharp edges can cut. Movement of parts can

cut off fingers or a hand. Wrap blade(s), wear

sturdy gloves and use extreme caution when

working near blades or impeller.

WARNING: PINCH POINT! Use extreme

caution when unclogging blower assembly.

Impeller can cut or pinch your hand, even when

not in operation. Wear sturdy gloves when

working near impeller.

WARNING: Blades rotate when impeller rotates.

Impeller rotates when blades rotate. Block

blades to prevent rotation before proceeding.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Comments to this Manuals

No comments

Ariens 991074-Max Zoom 52 Specifications Page 16

Comments to this Manuals