Ariens 991074-Max Zoom 52 Specifications download pdf (Page 11)

7. Connect the lower heat deflector to the bagger

mount weldment (item 4) with the hardware

removed in step 2. See Figure 7.

8. Install the heat deflection shield (item 8) on the

bagger mount weldment (item 4) with two

3/8-16 x 1/2 tapping screws (item 7). See Figure 7.

9. Install the bagger cover assembly (item 9) on the

bagger mount weldment (item 4) with two

9/16 x 1-3/8 flat steel washers (item 13) and two

5/16-18 clamping knobs (item 14). Keep them loose

until the bagger supports are installed. See

Figure 8.

10. Install the right bagger support weldment (item 11)

and the left bagger support weldment (item 10) on

the right and left side cover assembly. Secure the

supports to the cover assembly with a hair pin,

#25 (item 24) and to the unit frame with a 3/8-16 x 1

hex bolt (item 5) and 3/8-16 center lock

nut (item 12). Keep hardware loose until both

straps are installed, and then tighten all hardware.

NOTE: The left and right supports are different. Make

sure they are oriented properly before installation. Install

the right support first.

CAUTION: Exhaust gases can melt mesh bags

and cause a fire hazard. Make sure the exhaust

gases vent away from the mesh bags.

Figure 6

Tighten existing

tapping screw.

Figure 7

Connect existing lower heat

shield to bagger mount with

hardware removed in step 2.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Ariens 991074-Max Zoom 52 Specifications Page 11