Ariens 891003 Specifications Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
17
Ariens and Gravely Dealers will provide any service or
adjustments that may be required to keep your unit
operating at peak efficiency.
Maintenance Schedule
The chart below shows the recommended maintenance
schedule that should be performed on a regular basis.
Check Fasteners
IMPORTANT: Be certain that all hardware is tight before
each use. Pay special attention to the guards and safety
shields. Check tool-less hardware often. Tighten as
needed.
Inspect Bagger Parts
Before each use, inspect bagger parts for any holes,
abrasions, or structural damage. Replace any worn or
damaged parts.
Clean Unit
Clear away grass build-up in bagger before and after
each use.
Check Blower Belt
Check blower belt for wear every 10 hours; replace
blower belt if worn or deteriorated. See Figure 15.
Replacing Bagger Belt (Figure 15)
1. Remove belt guard.
2. Remove old or damaged belt.
3. Install new belt on blower assembly pulley and the
double pulley.
MAINTENANCE
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
MAINTENANCE SCHEDULE
Service Performed Each Use Every 10 hrs.
Check Fasteners
Inspect Bagger Parts
Clean Unit
Check V-belt •*
* Check V-belt tension after initial first two hours of use.
Figure 15
Note twist here.
Route tapered
section of the belt
here.
Route flat "back"
side of belt here.
52-inch deck shown.
Other decks similar.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comments to this Manuals

No comments